Frequent Questions for TS MEGA - Champ

Q17：After a lot of research I still cannot tell if the TS Mega can accept a midi clock from a drum machine that could be synchronized to the delay pedal in Bias fx (for it's repeat/echo timing). I have a Beatbuddy drum pedal that currently sends its BPS via midi to my Boss Delay to synchronize the timing between drums and delay, and I would want to keep that important feature using bias fx via your midi pedal. Further, if bias can accept the midi clock on the mega's midi-in to control the bias-fx delay, can it then send the same midi clock to another device via the midi-out jack?

The MIDI in of ts mega can accept midi notes or commands from other device and than into computer...

1

Q16:I am using a TS Mega device with my guitar, but searching through the manual, I cannot find an answer to this question: How do you change the sample frequency from the default of 44 kHz to the max of 192 kHz?

This can only be changed on a computer. For Windows or Mac systems, follow the normal operation o...

1

Q15：I have the Bias Fx app on my iPhone that I connect to my external audio interface which is connected to my studio monitor. I’d like to play in public and I need more volume for that. That’s why I’d like to know if the Melo Audio Tone TS Mega would the right solution if I connect my iPhone to it, and then connect the Melo Audio Tone TS Mega to the tube guitar amp combo. Will it work ? If it does, I should maybe tune the amp in order to have the cleanest sound as possible. If you know any tube amp combo that would fit my idea, any suggestion is welcome.

The output level of ts mega could be higher because of its internal line out driver as well as th...

1

Q14：Does it work on USB 3.0 or USB C？

Ts mini can also work with USB 3.0 and USB C ports. You can use it normally.

1

L-OUT & R-OUT Volume low

Hi, really like your controller, so i hooked up and get myself new monitor speaker - Kali LP-6 u...

2

Q10: Micro USB connector?

When I connect a micro USB power cable, the Tone Shifter Mega is not charging my iPad. Am I doing...

5

Not getting any signal in Bias Fx on ipad

I have my guitar plugged into the L-IN port on the TS Mega, which is plugged into my iPad through...

1

Lights flash dimly when I plug in iPad

When I plug in the iPad and the TS turns on, the lights flash dimly on and off and nothing happen...

1

momentary switch behavior - open source firmware?

I bought the TS Mega last summer, hoping to utilize it to simplify my live guitar setup. Unfortun...

2

Unable to Do MIDI Assignments on MacBook Pro with Bias FX with TS MEGA

I'm using Bias FX 2 on a MacBook Pro. I just got my TS MEGA and tried to do the MIDI assignments....

1

Unable to get it to work on Windows 10

As per instructions I installed the ASIO driver and it still isn't working. In device manager, th...

2

TS Mini audio interface problem

Hi, I have got TS mini audio interface for a while but I haven't used it. I have installed the dr...

2

Q13: I have the Bias Fx app on my iPhone that I connect to my external audio interface which is connected to my studio monitor. I’d like to play in public and I need more volume for that. That’s why I’d like to know if the Melo Audio Tone TS Mega would the right solution if I connect my iPhone to it, and then connect the Melo Audio Tone TS Mega to the tube guitar amp combo. Will it work ?

The output level of ts mega could be higher because of its internal line out driver as well as th...

1

Expression pedal calibration

I have a Mission expression pedal that i have plugged into my TS Mega. The TS recognizes the e...

2

Ipad switches presets but not sound

It seems to be correctly connected to ipad, either with Bias FX or JumUp. Presets change ok in th...

2

Switches instead of expression

What happens if I connect a simple foot switch to one of the expression inputs on the TS-Mega? Wi...

1

Q12: I was a little confused about the midi implementation. Can I use this as a midi interface for use with a midi controller to run synths within GarageBand on an iPad Pro? Thank for any guidance.

A: From all we tested, most of the music App can be used and supports both USB-Audio and USB-MIDI...

1

Display freezes after a while

I'm super happy with the TS Mega. But unfortunately the TS Mega display a lot of times freezes af...

1

Q11: What are the product dimensions?

The product dimensions: 25.5*13*4cm

1

Q7:Does the iPad have to be placed ON the Tone Shifter Mega or can I just buy a separate 5 meter USB cable and hide the iPad on the side of the stage while making changes to BIAS FX from the pedal？

A: It is achievable to hide the iPad on the side of the stage. We have a complimentary OTG cable ...

1

Q6: Is the headphone output really loud using 300ohm headphones at max volume (needs to be loud)?

A: The impedance of the headphone is relatively large and is subject to the actual sound.

1

Q5: Are TS MEGA three inputs and three independent outputs?

A: TS Mega has L Input for guitar/bass, R Input for dynamic microphone and one XLR Input for cond...

1

Q4: What would be the expected interface latency for INPUT and the OUTPUT latency in milliseconds at a 256 sample rate and at 44.1khz (24bit)?

A: The expected interface latency should be below 6ms.

1

Q3: Is this interface very low latency?

A: The delay size is related to the system audio buffer size, and usually, a satisfactory low-lat...

1

Q2: Is it somehow possible to disable the function of the Tone Shifter Mega to overwrite all output devices. I would love to be able using the output of my iPad or via Bluetooth when no device with Line/XLR In is available.

A: It is impossible. After connecting to the TS mega with the OTG cable, the iPad will output it ...

1

Q1: There two balanced 1/4 in output jacks on the ts mega. One is marked left and one is marked right. Which I presume are left and right stereo. if use just the left output is it a mono send?

A: Yes, if you use just the left output, it is a mono send. If your speaker has only one line, we...

1

Latest Topics

Midi In via USB? Tone Shifter

the PWR connector

Q8:Can the footswitches be setup in midi as either momentary or latch?

Momentary option for Looper hold action in looper apps

Pertanyaanq ts mega

No sound with TS Mini and Overloud THU mobile

Q9: No OTG Cable in Box

Strange behavior with TS Mini

Q16:I am using a TS Mega device with my guitar, but searching through the manual, I cannot find an answer to this question: How do you change the sample frequency from the default of 44 kHz to the max of 192 kHz?

Q14：Does it work on USB 3.0 or USB C？

L-OUT & R-OUT Volume low

Q10: Micro USB connector?

Not getting any signal in Bias Fx on ipad

Lights flash dimly when I plug in iPad

momentary switch behavior - open source firmware?

Unable to Do MIDI Assignments on MacBook Pro with Bias FX with TS MEGA

Unable to get it to work on Windows 10

TS Mini audio interface problem

Expression pedal calibration

Ipad switches presets but not sound

Switches instead of expression

Q12: I was a little confused about the midi implementation. Can I use this as a midi interface for use with a midi controller to run synths within GarageBand on an iPad Pro? Thank for any guidance.

Display freezes after a while

Q11: What are the product dimensions?

Q7:Does the iPad have to be placed ON the Tone Shifter Mega or can I just buy a separate 5 meter USB cable and hide the iPad on the side of the stage while making changes to BIAS FX from the pedal？

Q6: Is the headphone output really loud using 300ohm headphones at max volume (needs to be loud)?

Q5: Are TS MEGA three inputs and three independent outputs?

Q4: What would be the expected interface latency for INPUT and the OUTPUT latency in milliseconds at a 256 sample rate and at 44.1khz (24bit)?

Q3: Is this interface very low latency?

Q2: Is it somehow possible to disable the function of the Tone Shifter Mega to overwrite all output devices. I would love to be able using the output of my iPad or via Bluetooth when no device with Line/XLR In is available.

Q1: There two balanced 1/4 in output jacks on the ts mega. One is marked left and one is marked right. Which I presume are left and right stereo. if use just the left output is it a mono send?